This is a guide that shows how to install Monta on your charge point. If you want to connect your charge point to your Monta account, please follow the steps in the end of the guide.
Please note that when you connect your charge point to Monta, we become the operator of the charge point. This means that you need to use Monta to control the charging process.
Turn on or reboot the charge point and make sure the light indicator is flashing green.
Open mobile device’s or computer’s Wi-Fi settings and find a Hot-Spot with the name of your charge point’s serial number as follows “SN100…”
Enter the password “admin123” and click connect.
Now open a browser with the same device and enter this IP address 192.168.4.1 and open it.
The network pin is Admin123.
After logging in the web configuration click on “Charge Point Setup”.
In the “Charge point Setup” menu, select WiFi as the internet connection method and below click on the drop-down menu and find the WiFi that you want to connect to.
Enter the WiFi password in the third field and click “Confirm”.
Now the charge point will reboot automatically and will connect to Monta servers.
Now you need to add and connect your charge point to your Monta account.
You can add and connect your charge point by using the Powered by Monta flow.
Powered by Monta is an easy to follow flow, which Monta has developed with an exclusive set of manufacturers. Click here to read how you can use the flow via your phone.
You can also add and connect your charge point via Monta Hub.
